Connecting Peripheral Equipment; Video Recorder; Other Equipment; Headphones - Philips 70TA4416/03 Bedienungsanleitung

All manuals and user guides at all-guides.com

Connecting peripheral equipment

The EXT1 socket has audio, CVBS/RGB inputs and audio, CVBS outputs.
The EXT2 socket (if available) has audio, CVBS/S-VHS inputs and audio, CVBS outputs.

Video recorder

VCR

Other equipment

Headphones

Tips

Poor reception
The proximity of mountains or high buildings
may be responsible for ghost pictures, echoing
or shadows. In this case, try manually adjusting
your picture: see Fine Tuning (p.5) or modify
the orientation of the outside aerial.
No picture
Have you connected the aerial socket properly?
Have you chosen the right system? (p. 5).
The remote control no longer works.
Check that the mode selector on the side of
the remote control is set to TV.
No sound
If on certain channels you receive a picture
but no sound, this means that you do not have
the correct TV system. Modify the System
setting (p. 5).
Teletext
Are certain characters not displayed
correctly? Check that the Country setting
has been positioned correctly (p.5).
8
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable.You will therefore
need to tune in your video recorder's test signal and assign it
EXT 2
EXT 1
programme number 0 (refer to manual store, p. 5).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket
of the video recorder.You will then be able to record
scrambled transmissions.
Satellite receiver, decoder, CDV, games, etc.
Preferably connect the equipment delivering RGB signals
(digital decoders, DVD players, games consoles, etc.) to
EXT1 and the equipment delivering S-VHS signals (S-VHS
EXT 2
and Hi-8 VCRs) to EXT2.
EXT 1
When headphones are connected, the sound on the TV set
@
will be cut.The
level.
The headphone impedance must be between 32 and 600 Ohms.
Remote control
The TV set does not react to the remote
control; the indicator on the set no longer
flashes when you use the remote control?
Replace the batteries.
Standby
When you switch the TV set on it remains in
standby mode and the indication Locked is
displayed when you use the keys on the TV set?
The Child Lock function is switched On (p. 7).
If the set receives no signal for 15 mins, it
automatically goes into standby mode.
To save energy and preserve optimum picture
quality (by demagnetising the tube), you are
advised to switch off your TV set using the
on/off button at the front of the TV set.
Still no results?
If your TV set breaks down, never attempt to
repair it yourself: contact your dealer's after-
sales service.
0
.
#
P keys are used to adjust the volume