Commissioning And Operation; Manual Operation - Klarstein Mauna Loa 10035167 Bedienungsanleitung

COMMISSIONING AND OPERATION

• Temperature and serial number display: Normally, the display shows the room
temperature. When you adjust the temperature, the set temperature is displayed.
When you set the timer, the serial number is displayed.
• Time/temperature display: Normally, the current time is displayed. When you
set the timer, the set time is displayed. When you set the temperature of the weekly
timer, the set temperature is displayed.
• Time on and time off: Displayed when you set the timer and used in combination
with the serial number setting.
• Flame brightness: The current flame brightness level is displayed. The unit has 5
brightness levels.

Manual Operation

The unit can be operated either with the buttons on the right front of the unit above the
fire or with the remote control.
• The buttons are located on the right front above the fire. The standby button must be
pressed first.
• If you press „O/I " once, the appliance and the flame effect are switched on. If you
press and hold „O/I " for 3 seconds, the dimming mode is activated.
• Press the 1000 W button once for the low heating level. Press this button again to
deactivate the heating level.
• Press the 2000 W button once for the high heating level. Press this button again to
deactivate the heating level.
Using the remote control
• The standby button on the right front of the unit above the fire must be pressed first.
• It takes some time for the receiver to respond to the transmitter. Do not press a
button more than once within 2 seconds to ensure proper operation of the unit.
EN
29