Use And Operation - Klarstein 10028451 Handbuch

Mounting the Fireplace Stand
It is possible to install the electric fireplace on a surface, instead mounting it on the wall.
• Remove the tempered glass from the metal body.
• Place the metal body horizontally on a table.
• In the lower part of the body there are some holes; align them to the holes on the fireplace stand.
• Use the supplied screws to secure the base to the lower side of the main body.
• Place the unit on a flat and stable surface.
• With some help, install the tempered glass.
• Align the lateral hooks of the glass with the notches on the sides of the metal body.
The appliance can be operated either by the switches located on the top right hand side of the fire or
by the supplied remote control.
Manual Operation
• This is done by operating the switches located at the top right hand side of the fire .The
• standby rocker switch must first be switched on, the fire will beep to indicate that it is
• powered up.
• Press the O/I button once to turn on the appliance and fire effect. A red indicator light will
• show to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the
• dimmer mode, hold the button down until the desired brightness is obtained.
• Press the POWER button once for the low heat setting 1000W; press twice for the high
• heat setting 2000W; press three to switch off the heat setting.
• Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
Remote Operation
• The standby rocker switch located at the top right hand side of the fire must first be
• switched on; the fire will beep to indicate that it is powered up.
• It takes a little time for the receiver to respond to the transmitter. Do not press the buttons
• more than once within two seconds for the fire to operate normally.
• Press the ON/OFF button once to turn on the appliance and fire effect.
• Press the 1000W/2000W button once for the low heat setting 1000W; press twice for the
• high heat setting 2000W; press three to switch off the heat setting.
• Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
• Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and
• lower the brightness.
Safety Cut-Off
• This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. due to
blocked air vents).
• For safety reasons, the fire will NOT automatically reset.
• To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect to the mains supply and switch on the appliance.

Use and Operation

10