Klarstein Mauna Loa 10035167 Bedienungsanleitung Seite 30

EN
30
Activate device
1. Plug the power plug of the device into the power outlet.
2. Turn on the power switch.
3. Press the button ON/OFF on the remote control to start the appliance.
4. Press the 1000 W button to set 1000 W. Press this button again to deactivate the
heating level.
5. Press the 2000 W button to set 2000 W Press this button again to deactivate the
heating level.
6. Press the DIMMER button to activate the dimmer mode.
Room temperature control and open window detection
1. Press the button ON/OFF on the remote control or „O/I" on the unit. The
appliance is now in operating status and the heating setting is opened.
2. When you press the button
3. If the appliance detects that the room temperature suddenly drops rapidly, for
example because the window is open, the appliance will automatically stop the
heating function and the
4. The heating function cannot be activated automatically by the appliance within one
hour. To reactivate the heating function, press the button
open window detection.
Setting the day and time
1. The settings can be made with the remote control
2. First press the DATE/ TIME button, then press
3. Press the DATE/ TIME button again and press [+] or [-] to set the hour.
4. Press the DATE/TIME button again and press the [+] or [-] button to set the minute.
5. Press the OK button to finish.
Temperature Adjustment
The factory preset temperature is 20 °C. Press the [+] or [-] button on the remote control
to adjust the temperature. The adjustable temperature range is between 15 and 30 °C.
This only applies to the temperature setting in normal mode and not to the temperature
setting in timer mode.
Note: The set temperature must be higher than the room temperature. Otherwise the
unit will not heat.
on the remote control, the screen displays
icon will flash.
or to select the day.
.
to deactivate the