Description; Purpose; Overview; Safety - GreenWorks G24LT30M Bedienungshandbuch

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 16.
Trigger
1
Rear handle
2
Lock-out button
3
Auxiliary handle
4
Upper shaft
5
Coupler
6
Lower shaft
7
Guard
8
Edge guide
9
Cut-off blade
10
Trimmer head
11
Edge wheel
12
Pivoting button
13
Edger button
14
Battery release button
15
Spool cover
16
Spool
17
Spool housing
18
Guide slot
19
Hole
20
Spool retainer button
21
Direction of roatation
A
Best cutting area
B
Dangerous cutting area
C
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

Remove the battery pack from the machine before
installation.
WARNING
WARNING
English
Do not use accessories that are not recommended for this
machine.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

ATTACH THE GUARD

Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Install the guard into the slots on trimmer head.
3. Turn the guard counterclockwise to lock it into place.
4. Align the screw holes on the guard with the screw holes
on the trimmer head.
5. Tighten the screws.
3.3

ASSEMBLE THE SHAFT

Figure 3
1. Insert the lower shaft into the coupler on the upper shaft.
Make sure the upper and lower part of shafts are securely
tightened before installing the battery pack again.
2. Tighten the coupler.
3.4

INSTALL THE BATTERY PACK

Figure 4.
4
WARNING
WARNING
WARNING
WARNING
NOTE