Configuring A Dect Handset - Auerswald COMfortel WS-400 IP Inbetriebnahmeanleitung

3.
Enter the PBX's IP address in the Default domain entry
field.
4.
Select the codec priority in the Codec priority list fields.
Note: During operation on Auerswald PBXs, we recommend the
following codec priority configuration:
1: PCMA/8000 (G.711 A-law)
2-6: None
During operation on PBXs from other manufacturers, configure
the codec priority according to the available codecs.
5.
Click Save > OK.

Configuring a DECT handset

Requirements
– Knowledge of the handset data:
IPEI (available in the handset under Menu > Status >
General information)
Internal number, password (registered in the PBX)
1.
Open the Users page.
2.
Click New.
3.
Under DECT, enter the DECT handset's IPEI in the IPEI en-
try field. Format: 12-digit xxxxx xxxxxxx
4.
In the Access code entry field, enter the access code that
the DECT-handset
COMfortel WS-400 IP, e. g. 1234
5.
In the Standby text entry field, enter a text that shows when
the DECT handset is in idle state.
6.
Under SIP, enter the internal telephone number for the
DECT handset which you entered in the PBX in the User-
name/Extension entry field, e. g. 100.
7.
In the Display name entry field, enter the telephone number
you specified for the DECT handset in the PBX.
8.
In the Authentication user entry field, enter the internal tele-
phone number you specified for the DECT handset in the
PBX.
9.
In the Authentication Password entry field, enter the pass-
word you specified for the DECT handset in the PBX.
10.
Click Save.
COMfortel WS-400 IP - Setup V03 04/2014
should use
Commissioning
to register to the
31