Opening The Configuration Manager; Configuring The Comfortel Ws-400 Ip - Auerswald COMfortel WS-400 IP Inbetriebnahmeanleitung

The LED on the front cover flashes red followed by a
steady green if the COMfortel WS-400 IP has started.

Opening the Configuration Manager

Requirements
– Existing network connection between the PC and the
COMfortel WS-400 IP
– Knowledge of the COMfortel WS-400 IP's IP address
Note:
If a DHCP server is set up in the local network, the COMfortel
WS-400 IP will get its IP address from this DHCP server. You can
determine the IP addresses either via the DHCP server and the
COMfortel WS-400 IP's MAC address or via UPnP.
If no DHCP server has been set up, the static IP address
192.168.0.1 and the network mask 255.255.255.0 are used
instead after a waiting time of approx. 1.5 minutes.
– Knowledge of the access data (factory settings):
User name: admin
Password: admin (password before firmware version 14A:
ip6000)
1.
Start a browser (e.g. Mozilla Firefox).
2.
Enter the COMfortel WS-400 IP's IP address (e.g.
192.168.0.1) in the browser's Address bar.
3.
Enter the user name in the User name entry field.
4.
Enter the password in the Password entry field.
5.
Click OK.
The Configuration Manager opens.

Configuring the COMfortel WS-400 IP

Requirements
– PBX with the following features:
available internal VoIP channels
configured internal SIP subscribers (telephone number,
user name, PIN/password)
COMfortel WS-400 IP - Setup V03 04/2014
Commissioning
http://
29