1.
Mark holes on the wall where you intend to mount the device.
Important: Make sure there are no electrical leads, or gas or
water pipes, in the area in which you want to drill the holes.
2.
Drill the holes (diameter 6 mm) and insert the dowels into
them.
3.
Screw in the screws far enough that the screw head is about
5 mm away from the wall.
4.
Hang the device on the screws and move it downwards on
the wall until it hangs securely.
Note: Ensure the screws do not touch the circuit board.
COMfortel WS-400 IP - Setup V03 04/2014
Preparation
27