Network Settings; Security Settings; Sip Settings - Auerswald COMfortel WS-400 IP Inbetriebnahmeanleitung

Commissioning

Network settings

1.
Open the Configuration > General page.
2.
Select one of the following options from the Method list field
displayed under IPv4:
Use Static IP Address: The COMfortel WS-400 IP is
assigned a fixed IP address (recommended).
DHCP assigned: The COMfortel WS-400 IP gets its IP
address automatically from a DHCP server.
3.
Only for Use Static IP address:
Enter the COMfortel WS-400 IP's IP address in the
IP addr entry field.
Enter the network mask in the Netmask entry field.
Enter the gateway name in the Gateway entry field.
4.
Under NTP, enter the NTP server's IP address in the Server
entry field.
5.
Select the time zone from the Time zone list field.
6.
Click Save > OK > Reboot now > OK.
This restarts the COMfortel WS-400 IP.

Security settings

1.
Open the Configuration > Security page.
2.
Enter the current password in the Current Password entry
field.
3.
Enter a new user name in the New username entry field.
4.
Enter a new password in the New password entry field.
5.
Then enter the new password again in the New password
again entry field.
6.
Click Save > OK.

SIP settings

1.
Open the Configuration > SIP page.
2.
Under General, enter the number of the SIP port in the Local
port entry field.
Note: The standard port 5060 is already set up. Configure the
port according to the port configuration in the PBX.
30
COMfortel WS-400 IP - Setup V03 04/2014