Product Care - Ossur FORMFIT TRACKER Gebrauchsanweisung

2. Push the hinges out of the brace through the openings on the hinge
pockets (Figure 9).
Putting the hinges back
To put the hinges back into the brace, do as follows:
1. Pull the strap ends off of the brace and fasten them to the strap
(Figure 6). Fasten as the dots show you.
2. Push the hinges into the brace through the openings on the hinge
pockets (Figure 9).

PRODUCT CARE

You can wash the brace without removing its components.
Wash on a delicate cycle at max 30 °C with a mild detergent. Leave to air
dry. Do not tumble dry.
NOTICE: Make sure to fasten the strap ends before washing. If you do
not fasten the strap ends, they can damage the brace materials.
REPORT A SERIOUS INCIDENT
Important notice to users and/or patients established in Europe:
The user and/or patient must report any serious incident that has occurred
in relation to the device to the manufacturer and the competent authority
of the Member State in which the user and/or patient is established.
DISPOSAL
The device and packaging must be disposed of in accordance with
respective local or national environmental regulations.
LIABILITY
Össur does not assume liability for the following:
• Device not maintained as instructed by the instructions for use.
• Device assembled with components from other manufacturers.
• Device used outside of recommended use condition, application, or
environment.
7