Motorola MTM800 E Ausführliche Bedienungsanleitung Seite 109

Message
No Service
Not Allowed To Initiate Call
Not Allowed To Transmit
Single TalkGroup Only
Overheating, Please Turn Radio Off
Party Busy
Party Not Available
Please Try Again
Please Wait Connecting
Registration Failure
Repeater available
Repeater not available
Service Denied
Service Not Available
Service Restricted
TalkGrp ... cannot be deleted
Try Again Later
Radio Disabled
Unit is OK
Warn:
Unit Not Attached
Unassigned Button
CP setting error:
CH Role Selection
CH is powering OFF
Standalone Mode
Radio is powered OFF
No available services
Software Error:
Message Description
Your radio is out of coverage.
You are not allowed to dial a number which is not in the address
book.
Release the PTT button and try again later. You are not allowed to
send a text message or a status message to a number which is not in
the address book.
There is only one programmed entry in the scrolling list.
Your radio turns off. Keep it turned off for 5 minutes.
Called radio is busy.
Called radio is out-of-range or turned off. Please try again later.
You could not call.
A message during startup.
Your radio could not register within the system. Please try again later.
Your radio has connected to a repeater.
Your radio cannot connect to a repeater, or connection has been lost.
Invalid number. Call your service provider.
This service is not available on the current network.
This service or feature is restricted by your service provider, it has
not been purchased, or it is not available.
Your service provider set this group so you cannot delete it from the
favorite talkgroup folder.
The requested service is temporarily unavailable.
Check with your service provider.
Self-test error. A minor fault has been detected. Your radio is still
fully operative. If this error recur, note the error code and contact
service.
You radio could not attach to the system. The talkgroup may not be
defined in the system. Please try another group.
The message is displayed when no feature is assigned to a button.
The message is displayed when the control head configured as Slave
is connected to the Transceiver and the control head configured as
Master is connected as standalone (i.e. not to the Transceiver).
The message is displayed on Slave Control Head in Standalone mode.
The message is displayed on Slave Control Head only when the
software version is different than on Master.
Troubleshooting | 109
Table continued...
| | Send Feedback