Disposal; Technical Data; Order List; Declaration Of Conformity - Dräger PID 5000 Gebrauchsanweisung

en

Disposal

7 Disposal
Electric and electronic equipment are subject to
national and international waste disposal regulations
and must not be disposed of as residential waste. This
is indicated by the adjacent symbol. Further
information is available online at www.draeger.com.
Dräger accepts returns of waste electrical and
electronic equipment for recycling or disposal.
8

Technical data

The indicated values were measured under standard
conditions. Isobutylene in synthetic air was used as the test
gas.
Measuring range 0 to 1.6 mg/m³
Lower detection limit 0.01 mg/m³ (based on isobutylene)
Accuracy ±0.01 mg/m³ (based on isobutylene)
Display resolution 0.01 mg/m³
Response time Approx. 6 min
Influence of humidity Dew point of the measuring gas
< -20 °C
Relative humidity 0 to 95 % rH, non-condensing
Operating 0 to +50 °C
temperature
Storage temperature -20 to +60 °C
Gas flow 0.2 to 0.5 L/min
Alarms 2 adjustable alarm thresholds
Power supply 9 to 36 VDC, max. 4 W,
recommended: 24 VDC
Display 2 LEDs (red) for alarms, 1 LED (multi-
coloured) for status
Analogue output Current loop, 4 to 20 mA
Response factors Adjustable between 0.1 and 10 in
steps of 0.01
User interface Graphic display with backlight,
magnetic controls
Dimensions, weight 133 mm x 150 mm x 158 mm
(L x W x H), approx. 2,500 g
Protection class IP64
Factory settings
Alarm levels Alarm LO
Alarm HI
Current loop Output
Signal
Measuring time Gas inlet
(measurement)
Gas inlet
(reference)
Response factor
Password
16
9
Designation
Magnetic pen
Test gas: Isobutylene 5 ppm
Dräger-Tubes activated
carbon type G (pack of 10)
(for gas treatment)
10
0.3 mg/m³
0.5 mg/m³
4 to 20 mA
0 to 1.60 mg/m³
3 min
3 min
2.33
0002

Order list

Ordering no.
45 44 101
68 13 685
67 28 831

Declaration of Conformity