Initial Start-Up; Structure; Before Starting Up For The First Time; Language Selection In Windows - Bosch FSA 740 Edition Originalbetriebsanleitung

en 22 | FSA 740 Edition |
4.

Initial start-up

4.1

Structure

1. Remove the packaging and the transport locks on all
parts delivered.
2. Connect the sensors to the specified slots in the
measuring unit (see fig. 3). Only connect current
clamp 30 A and 1000 A as well as adapter line
1 684 465 513 if necessary.
3. Insert the printer into the trolley (fig. 1; item 8).
4. Plug in power cord and the USB connecting cable to
the printer. Both cables are provided ready for con-
nection in the trolley.
i
The printer cartridges can only be used when the
printer is switched on.
4.2

Before starting up for the first time

The voltage supply is provided via the lighting mains.
In the factory, FSA 740 Edition has been set to 100 V -
230 V, 50/60 Hz. Read the information on the sticker on
the side of the FSA 740 Edition carefully.
!
Before starting up, ensure that the voltage of the
lighting mains matches the voltage set on the
FSA 740 Edition. If the FSA 740 Edition is operated
outdoors, we recommend using a voltage source
which is fused by means of an FI circuit breaker.
4.3

Language selection in Windows

After switching the device on the first time, select a
language for the Windows operating system in a menu.
You cannot change this language at a later date. How-
ever, if this is necessary, contact your Bosch authorized
dealer.
4.4

Commissioning KTS module

The commissioning of the KTS module is described in
the product description 1 689 989 223 and in the On-
line Help from DDC.
1 689 989 089 | 2018-03-24
5.

Operation

5.1

Switching the FSA 740 Edition on/off

Switch the FSA 740 Edition on or off with the central
mains switch on the rear of the device (see fig. 2;
item 5).
i
Before switching off the device, shut down the PC
using the Windows operating system. Wait at least
60 seconds before switching the device back on
again.
i
When operating the FSA 740 Edition, faults may oc-
cur if a PC or other components (e.g. mouse, con-
necting cables) from suppliers other than Bosch are
used.
5.2

Notes on measurement

DANGER – Risk of electric shock if measure-
ments are taken on motor vehicles without
connecting cable B–!
Measurements taken with connecting cable
B– not connected to vehicle ground or the
negative post of the battery will result in
injury, heart failure or fatal electric shocks.
¶
For all measurements, connect the
FSA 740 Edition by way of connecting
cable B – to vehicle ground or the nega-
tive post of the battery.
DANGER – Risk of electric shock from ex-
cessively high measurement voltage.
The measurement of voltages in excess of
60 VDC/30 VAC/42 VACpeak using Multi
measurement leads CH1 / CH2 will result in
injury, heart failure or fatal electric shocks.
¶
Never use Multi measurement leads CH1 /
CH2 to measure mains or similar voltages.
!
Measurements with FSA 740 Edition are only permit-
ted in a dry environment.
!
The FSA 740 Edition is not to be used for check-
ing isolation from the supply on electric and hybrid
vehicles. Measurements on high voltage capacitator
ignitions are not permitted, as voltage values above
300 Volt are present for this ignition type.
Robert Bosch GmbH