Initial Start-Up; Structure; Before Starting Up For The First Time; Language Selection In Windows - Bosch FSA 760 Edition Betriebsanleitung

4.

Initial start-up

4.1

Structure

1. Remove the packaging and the transport locks on all
parts delivered.
2. Connect the sensors to the specified slots in the
measuring unit (see Fig. 3). Only connect current
clamp 30 A and 1000 A as well as adapter line
1 684 465 513 if necessary.
3. Insert the printer into the trolley (Fig. 1; item 8).
4. Plug in power cord and the USB connecting cable to
the printer. Both cables are provided ready for con-
nection in the trolley.
i
The printer cartridges can only be used when the
printer is switched on.
4.2

Before starting up for the first time

The voltage supply is provided via the lighting mains.
In the factory, FSA 760 Edition has been set to 100 V -
230 V, 50/60 Hz. Read the information on the sticker on
the side of the FSA 760 Edition carefully.
BEA 050 has been set to 230 V in the factory. The trans-
former mains voltage must only be adjusted by autho-
rized service personnel. For more information, refer to
the instructions in the BEA 050 documentation.
!
Before starting up, ensure that the voltage of the
lighting mains matches the voltage set on the
FSA 760 Edition. If the FSA 760 Edition is operated
outdoors, we recommend using a voltage source
which is fused by means of an FI circuit breaker.
4.�

Language selection in Windows

After switching the device on the first time, select a
language for the Windows operating system in a menu.
You cannot change this language at a later date. Howe-
ver, if this is necessary, contact your Bosch authorized
dealer.
4.4 Commissioning KTS 5��, KTS 54�,
KTS 5��
The commissioning of the KTS module is described in
the product description 1 689 979 987 and in the On-
line Help from DDC.
Robert Bosch GmbH
Initial start-up | FSA ��� �dition | 21
5.

Operation

5.1 Switching the FSA ��� �dition on/off
Switch the FSA 760 Edition on or off with the central
mains switch on the rear of the device (see Fig. 2;
item 5).
i
Before switching off the device, shut down the PC
using the Windows operating system. Wait at least
60 seconds before switching the device back on
again.
i
When operating the FSA 760 Edition, faults may oc-
cur if a PC or other components (e.g. mouse, con-
necting cables) from suppliers other than Bosch are
used.
5.2

Diagnostic Software Access DSA

With DSA, you can:
R
Start Bosch applications (automatically as well).
R
Make interface settings.
R
Select DSA and Bosch application language.
R
Install software.
R
Update customer and vehicle data.
R
Terminate Bosch applications.
You will find more information in the DSA online help.
5.�

Start screen for FSA system software

Fig. 4: Start screen after device is switched on
i
If several applications are open, the speed of the
FSA system software may be impaired.
FSA ��� �dition | 21 | 21 en
1 689 989 078 | 2012-01-20