Lenze 8200 motec Montageanleitung Seite 135

Keypad
ce6

ce7

EEr

ErP0
...
ErP19

FAn1

FAn1
H05

id1

LP1

LP1
LU

L
Downloaded from www.Manualslib.com
efesotomasyon.com - Lenze
Fault detection and elimination
1)
PC Fault
67 System bus (CAN)
function module
on FIF has the
"Warning" or
"BUS-OFF" status
(configurable in
C0126)
68 Communication
error in case of
remote
parameterisation
via the system
bus (C0370)
(configurable in
C0126)
91 External fault
(TRIP-SET)
- Communication
abort between
keypad and
standard device
Fan failure
95
(only 8200 motec
3 ... 7.5 kW)
TRIP or warning
-
configurable in
C0608
105 Internal fault
140 Faulty parameter
identification
32 Error in motor
phase
(Display when
C0597 = 1)
182 Error in motor
phase
(Display when
C0597 = 2)
- DC bus
undervoltage
manuals search engine
Cause
CAN controller signals
"Warning" or "BUS-OFF"
status
Node does not respond or is
not available
When operating with
Application I/O:
Parameter set change-over
has been parameterised
incorrectly
A digital signal assigned to the
TRIP-set function is activated
Various
Fan is defective
Fan is not connected
Motor is not connected
Failure of one/several
motor phases
Motor current too low
Mains voltage too low
Voltage in DC-bus connection
too low
EDK82MV222 DE/EN/FR 9.0
Fault messages
Remedy
Check whether bus termination
is available
Check shielding of the cables
Check PE connection
Check bus load, reduce the
baud rate, if necessary
Check whether bus termination
is available
Check shielding of the cables
Check PE connection
Check bus load, reduce the
baud rate, if necessary
In all parameter sets, the "change
over parameter set" signal
(C0410/13, C0410/14) must be
connected with the same source
Check external encoder
Contact Lenze
Replace fan
Connect fan
Check wiring
Contact Lenze
Connect motor
Check motor supply cables
Check U boost,
min
Connect motor with a
corresponding power or adapt
motor with C0599
Check mains voltage
Check power supply module
U
NPR