Technical Data; Declaration Of Conformity - Schwamborn DSM 530 Originalbetriebsanleitung

EN Floor grinding machine DSM 530

6 Technical data

Risk of injury from tilting frame!
The following tasks (b. to d.) must be carried out
by 2 persons! One person has to always hold
the carriage by the guide handle [1, Fig. A].
b. Loosen the 4 screws [27, Fig. H] as far as
possible without removing them, so that
the bolts [28, Fig. H] are movable.
c. Push the bolts into the open position [Fig. H].
d. Disconnect drive from the frame.
e. If necessary (e. g. for lorry transport),
screw the 4 screws [27, Fig. H] tightly and
fasten all loose parts on the frame.
f. If necessary, lift drive and frame onto a
suitable transport device (e.g. a pallet). If
applicable, use suitable lashing gear (belts,
ropes, or chains).
g. Transport the drive and frame to the re­
spective location and set down.
Reassembly is performed in the logical reverse
order.
6 Technical data
Designation
Rated voltage
Rated frequency
Rated current
Rated power
Connecting cable 5 x min. 2.5 mm
5 x min. 4.0 mm
Tool
Speed
Protection rating
Dust extraction
Tank capacity
Dimensions (L x
W x H)
Working width
Edge distance
Grinding wheel
Grinding head
weight
Value Unit
400 V, 3
50 Hz
8.2 A
4 kW
2
(max. 25 m)
2
(>25 m)
438 ... 1136 rpm
IP 23
 50 mm
about 10 litres
about 1092 x 579 x mm
957
 530 mm
min. 10 mm
3 x  200 mm
106 kg
Total weight
Noise level
Vibration total va­
lue*)
*) Determined under standardised manufacturer oper­
ating conditions according to the HARM measuring
method

7 Declaration of conformity

Schwamborn Gerätebau GmbH
Robert‐Bosch‐Straße 8
D‐73117 Wangen
Germany
We hereby declare that the machine
DSM 530
complies with the provisions described in
— Directive 2006/42/EC
Machines
— Directive 2004/1 08/EC
Electromagnetic Compatibility
— Directive 2006/95/EC
Low Voltage
The following harmonised standards apply:
— EN 292‐1, EN 292‐2, EN 13857
Safety of Machinery
— EN 60204‐1
Electrical Equipment of Machines
— EN 62079
Creating operating instructions
It is forbidden to begin operating a modified or retro­
fitted machine before it has been determined that the
modified or retrofitted machine conforms to the above
directives.
This declaration is no longer valid if the machine is
modified or retrofitted without our prior consent and
approval.
The original operating manual with the Declaration of
Conformity and translation into the respective Euro­
peannational language is supplied with the machine.
Wangen, 1.11.2018
Eckart Schwamborn
Managing Director
150 kg
79 dB
2
<2.5 m/s
21