Inhaltsverzeichnis
Werbung
ing use, follow these procedures for
proper assembly.
Changing/Installing Batteries
The micro CA-350x is supplied without the
battery installed. If the battery indicator dis-
plays
, the battery needs to be recharged.
Re move the battery prior to storage.
1. Squeeze the battery tabs (See Figure 5)
and pull to remove battery.
Figure 5 – Removing/Installing Battery
2. Insert contact end of battery into the in-
spection tool, as shown in Figure 5.
Powering with the AC Adapter
The micro CA-350x Inspection Camera can al -
so be powered using the supplied AC Adapter.
1. Open the right side port cover (Figure 3).
2. With dry hands, plug the AC adapter into
the outlet.
3. Insert the AC adapter barrel plug into the
port marked "DC 12V" .
Figure 6 – Powering the Unit with AC Adapter
Installing the Imager Head
Cable or Extension Cables
To use the micro CA-350x Inspection Cam er -
a, the imager head cable must be connected
to the handheld display unit. To connect the
cable to the handheld display unit, make sure
the camera socket key and display unit socket
999-995-164.09_Rev. A
micro CA-350x Inspection Camera
slot (Figure 7) are properly aligned. Once they
are aligned, finger tighten the knurled knob to
hold the connection in place.
Figure 7 – Cable Connections
3' (90 cm) and 6' (180 cm) cable extensions are
available to increase the length of your camera
cable up to 30 feet (9 m). To install an extension,
first remove the camera head cable from the
display unit by loosening the knurled knob.
Connect the extension to the handheld as de-
scribed above (Figure 7). Connect the keyed
end of the camera head cable to the slotted end
of the extension and finger tighten the knurled
knob to hold the connection in place.
Installing Accessories
The three included accessories, (Hook, Mag -
net, Mirror) all attach to the imager head the
same way.
Flats
Figure 8 – Installing an Accessory
To connect, hold the imager head as shown in
Figure 8. Slip the semicircle end of the acces-
sory over the flats of the imager head. Then ro-
tate the accessory a 1/4 turn to retain.
Installing SD™ Card
Open the left side port cover (Figure 4) to ac-
cess the SD card slot. Insert the SD card into
the slot with the angled corner up, matching
the icon next to the slot (Figure 9). SD cards
can only be installed one way – do not force.
When an SD card is installed, a small SD
card icon will appear in the upper left hand por-
tion of the screen, along with the number of im-
ages or length of video that can be stored on
the SD card.
Accessory
1/4 Turn
7
Werbung
Inhaltsverzeichnis
