Werbung
MUE2-S01 adjustable rearset
Sicherheitshinweise/ Safety
You must read these Installation Instructions carefully and make sure you
understand everything they contain, before commencing work.
Thank you for purchasing one of our products and we wish a lot of enjoyable riding. With Gilles
you make a standard bike - your bike.
-Safety always comes first.
-Do you have the correct tools?
-Do you have the ability and aptitude to confidently mount thes product. If in doubt consult a skilled
technican.
-We always advise fitment is carried out by skilled personal.
-Non-compliance with the instructions can be hazardous. For your own protection and the safety of the
bike please always follow the instructions.
-Any Gilles parts will not be covered by warranty it fitted incorrectly.
General instructions
-Please ensure the motorcycle is adequately secured before commencing work.
-Always make sure that the motorcycle is stable and firmly supported.
-A hot engine and exhaust system can burn. Allow all hot parts to cool before commencing work.
-Keep children and household pets well away from the work zone.
-Remove all items of personal jewellry (rings, chains,wristwatch, etc.) before commencing work.
-The fitment instructions relate only to the fitment on a standart motorcycles.
-We cannot warranty or legislate for interaction or interference with non standard or custom parts.
-If a technican is installing the parts please ensure these instructions are passed to the owner.
-Please keep the instruction manual at a safe place. In case of selling our product, please hand the
installation instructions over to the new owner.
- Consult info@gillestooling.com if the instructions in question are no longer in your possession.
Operating licence
-Always comply with the regulations regarding approval in the country of use.
-For the Federal Republic of Germany:
A entry in the vehicle´s registration papers is not necessary!
Assembling note
-Screws, bolts and nuts are tightened in accordance with the applicable DIN/ISO standarts. Tightening
torques that deviate from the standards are stated.
- All threaded connections and bearings must be greased with suitable grease. Please be careful with
the tools to avoid i.e. scratches.
-Mounting and bleeding at the brake system only by skilled personal.
-Take care that no wires and hoses (especially brake hoses) are too close or touching other
components or moving parts.
-After each mounting check all bolts for correct tightening and specified torque moment.
-Take care that any parts always have a minimum clearence of 5 mm to any moving parts.
3/8
31.10.2017
Werbung
