Cleaning The Spray Arms; Internal Cleaning; External Cleaning; Troubleshooting - Electrolux ESF 7530ROW Benutzerinformation

11.2 Cleaning the spray arms

Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.

11.3 External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with the
help of the information in the table.
Problem and alarm code Possible solution
You cannot activate the ap-
pliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no a damage fuse in the fuse
box.
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance has started the procedure to recharge
the resin inside the water softener. The duration of the
procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
.
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog-
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
.
• Close the water tap and contact an Authorised Service
Centre.
.

11.4 Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a
soft moist cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per
month.
With some problems, the display
shows an alarm code.
ENGLISH 35