Before You Start The Installation; Setting Up The Camera In Your Stable - Luda Elektronik horseCam Bedienungsanleitung

6. Before you begin the installation
Read the whole user guide before you start installing your horseCam-solution.
Begin with charging your LCD-monitor. You will need to use it later on
in the installation process. The battery is only partially charged at
delivery, the LCD-monitor will only function for a short while if not
charged. A fully charged battery will last for approximately 2
hours.
1. Place one of the included batteries inside the
LCD-monitor.
2. Connect the power adaptor marked with 5V to
the LCD-monitor's power socket (marked with DC
5V IN) and the other end to a wall socket (220V).
3. Make sure that the ring around the button on the LCD-
monitor lights up. The light will turn off when the battery is
fully charged.
NOtE!
Only use the 5V adapter marked LCD Monitor to power the
monitor! Usage of any other power source may damage the
receiver and is NOT covered by the warranty.

7. Setting up the camera in your stable

1. Connect the small camera antenna to the back of the
camera.
2. Attach the camera to the wall, 2 m* from a 220V
socket and 12 m* from where you intend to place the
transmitting A300-antenna.
3. Use the LCD-monitor to check the camera angle.
*Low voltage power extension cables and longer antenna cables can
be purchased from your local retailer.
Downloaded from www.Manualslib.com manuals search engine
- 35 -
DC
5 V
12V
DE
EN
ES FR
FI
SV
FR
IT
PL
SV