Herunterladen Inhalt Inhalt Diese Seite drucken

Luda Elektronik horseCam Bedienungsanleitung Seite 41

Vorschau ausblenden Andere Handbücher für horseCam:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
5.
Make sure that the camera is working by screwing the small black antenna back on and
holding the LCD monitor nearby.
If you do not receive a picture using the small antenna, contact the support.
If you do receive a picture using the small antenna, please screw the A300 antenna cable
back on a nd check that the antennas are mounted with the "spikes" horisontally, that the
cable isn't damaged and that the cables are connected properly.
If you can't find any problem with the antennas, go to section 6.
6. Begin with making sure the channel switchers are set correctly. The switch to the right
marked with M L sets the videoLink to Automatic Channel Looping (L) or Manual Channel (M).
The important switches for the troubleshooting are the four other switches. By setting them to
on or off, you choose which channels the videoLink is to receive on, in other words the
channel(s)l your camera(s) is sending on. For example, if the camera is sending on channel 4,
the switch marked 4 should be set to ON. (Pointing down)
On the top side of the videoLink, on the right side (Receiver) you will see the receiving
channels you have chosen. If we follow the example above we will see number 4 lit up. On
the left side (Transmitter) you will see the channel the videoLink is retransmitting the camera
signal on. The transmitting channel must not be the same as the receiving channel. In our
example it would be suitable to let the videoLink transmit on channel 1 or 2.
When troubleshooting the videoLink, choose the transmitting channel of the videoLink
on the LCD monitor.
If you only see noise in the LCD monitor and no LEDs on the videoLink are lit up, please
check that the adapter is connected to a working socket, connected to the videoLink, marked
5V and that the cable isn't damaged in any way.
If the LEDs on the videoLink are lit up, but you only see noise in the LCD monitor, check that
the channels are set correctly.
If you see interference in the picture, please go to chapter 17, Interference.
Downloaded from
www.Manualslib.com
manuals search engine
- 41 -
DE
EN
ES
FR
FI
SV
FR
IT
PL
SV

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Luda Elektronik horseCam

Inhaltsverzeichnis