Setting Up The Transmitting A300-Antenna - Luda Elektronik horseCam Bedienungsanleitung

8. Installing the transmitting A300-antenna
In order to send the picture from the camera wirelessly at the longest possible range, the A300-
antennas must be placed on the outer walls of the buildings, pointing directly at each other.
1. Unplug the camera power supply.
2. Remove the small camera antenna.
3. Attach the antenna cable to the camera and
drag the cable to the wall on which you have
chosen to place the transmitting A300-
antenna.
4. Attach the antenna to the wall temporarily
using only 1 or 2 screws.
5. Slide the shrink tube onto the antenna cable,
connect the antenna cable to the A300-
antenna. Do not heat the shrink tube yet!
a
This step is done after you have made sure
that you receive interference-free picture
quality inside your house.
Downloaded from www.Manualslib.com
INfOrMAtION
Place the antenna as illustrated above to obtain optimal picture quality.
Make sure there are no other objects such as a roof gutter or a pipe close to the
antenna, as it may decrease the image quality.
c
b
c1
c2
c3
manuals search engine
90˚
test the signal reception
As the receiving A300-antenna is significantly
more sensitive than the built-in receiving
antenna of the LCD-monitor, a somewhat
unstable picture is acceptable at this point.
1. Plug in the power to the camera again.
!
2. Test the signal reception by bringing
your LCD-monitor to the place where
you intend to put the receiving A300-
antenna. Generally you achieve a better
signal quality when placing both
antennas as high as possible.
- 36 -
90˚