Luda Elektronik horseCam Bedienungsanleitung Seite 43

NOtE!
Only use the 12V trailer cable with the camera.
Only use the 5V cigarette adaptor with the LCD monitor.
1. Make sure there is no power in the trailer by disconnecting
the trailer from the car. Connect the 12V trailer power
cable to an existing power source inside the trailer.
Connect the horse shoe joint of the white-striped cable
to the positive pole (+) and the horse shoe joint of the all
black cable to the negative pole (-) of the power source.
2. Attach the black camera antenna (2dBi) to the camera.
3. Connect the car to the trailer. Start the car and ensure that
the red LED on the adaptor box is illuminated.
4. Connect the other end of the cable to the camera.
5. Hold the camera in a suitable position inside the trailer, maximum 1,5 meters from an existing
power source.
6. Bring the LCD-monitor to the car cabin to make sure you receive a satisfying picture quality
and trailer overview.
7. Mount the camera using the included nuts and bolts.
8. Place the LCD-monitor holder in your car. Make sure that the holder does not block the
driver's field of vision.
9. Connect the 5V cigarette adaptor to the car cigarette lighter socket and the LCD monitor.
If questions or problems arise during the installation, read through chapter 16, Troubleshooting in
the trailer.
Downloaded from www.Manualslib.com
INfOrMAtION
To be able to see the horse in the trailer even when you have left the car you need
an alternative power source since the power to the trailer is cut when the engine
is turned off. You can purchase a battery pack for powering the camera from your
local retailer.
manuals search engine
- 43 -
DE
EN
ES FR
FI
SV
FR
IT
PL
SV