Troubleshooting In The Trailer - Luda Elektronik horseCam Bedienungsanleitung

16. Troubleshooting in the trailer

In this Troubleshooting chapter we will presume that you have mounted and installed all parts of
your horseCam system.
Troubleshooting is also available online at http://ludaelektronik.com/support/en/
Please read chapter 23 for contact information to our support team.
1. We will start troubleshooting by using the portable LCD monitor.
– If you can't see a picture on any of the channels, and the monitor is completely black, go to
section 2.
– If the picture is black on one or more channels, but not all, contact the LUDA Support.
– If there is only noise on all channels, go to section 3.
– If there is interference in the picture, read chapter 17, Interference.
– If you see a bright circle in the picture, read chapter 17, Interference.
– If the picture is black and white/lacking in colour, read chapter 17, Interference.
– If the contrast is very sharp, read chapter 17, Interference.
2. Make sure that the monitor is connected to a power source and is turned on. One of the
channel indicators should light up, and when charging the red ring around the channel
button should be lit up as well. If no LEDs are lit please check the following:
– That the battery is charged. Charge by using the included 5v adapter or change battery. If the
battery seems to have very short battery life, you may need to get a new one.
– If you experience problems with charging the monitor try using the 220v adapter instead of
the cigarette adapter and vice versa. If charging works with one but not the other, contact us
to get a new adapter.
– If the display is black despite the LCD monitor is receiving power, please contact the support.
Never charge the monitor with any other adapter than the included 5v adapters! Charging with
the wrong adapter may lead to damage on the equipment not covered by the warranty.
3. Check if the camera is supplied with power by cupping your hands around and peeking
into the camera lens. the darkness should make the Ir light turn on, and you should
see a red light.
– If you see a red light, the camera is supplied with power. Proceed to step 4.
– If not please check that the power is properly connected to the c amera, and that the cable
isn't damaged in any way.
4. Make sure that the camera is working by holding the LCD monitor nearby and
switching between all channels.
– If you do not receive a picture, contact the LUDA support team.
Downloaded from www.Manualslib.com manuals search engine
- 44 -