Equipment Variants - HBM C15 Bedienungsanleitung

Scope of supply and equipment variants
3.3

Equipment variants

The C15 force transducer always comes supplied with an adapter (lower load
application).
Fig. 3.1 C15 on delivery with bayonet connector and load application bolts and
double bridge
The force transducer is available in different versions. The following options are
available:
1. Nominal (rated) force
You can purchase force transducers with nominal (rated) forces between
2.5 kN and 1 MN. The nominal (rated) force is the force at which the sensor
provides the rated output specified on the type plate as the output signal.
2. Number of measuring bridges
You can purchase the force transducer with a single bridge (SB), and then
the C15 comes supplied with one measuring bridge. The double-bridge ver­
sion (DB) is available as an option. In this case, the C15 is supplied with
two electrically isolated bridge circuits, so that two independently working
bridge amplifiers can be connected.
3. Transducer identification
You can purchase the force transducer with transducer identification
("TEDS"). A TEDS (Transducer Electronic Data Sheet) chip allows you to
10
A05091_01_YCI_02 HBM: public
C15