Migatronic RWF2 Betriebsanleitung Seite 9

Connection and operation
Error codes
When the RWF
following error codes can be displayed on the control
panel:
lost.
too high pressure on the gas flow or poor flow in the
welding hose.
Make sure that the pressure on the gas flow is higher
than 2 bar and less than 6 bar, corresponding to 5 l/min
and 27 l/min.
Gas fault can be set out of action by adjusting the
manual gas flow to 27 l/min.
Technical data
Duty cycle 100% 40°C, A/%
Duty cycle 60% 40°C, A/%
Wire feed speed, m/min
Torch connection
Wire diameter, mm
Gas pressure max., MPa (bar)
Touch Sense max. voltage, V
Touch Sense max. current, mA
Dimensions (HxWxL), mm
Standards
Weight, kg
Protection class
1
This machine is designed for indoor operation and meets the
1)
requirements of protection class IP21
Downloaded from www.Manualslib.com
is connected to the power source, the
2
is displayed when communication
between the power source and RWF
is displayed when controlling the motor
is not running properly.
is displayed when the motor is
overloaded.
Info: Touch sensing
Touch sensing function is activated
Gas control fault (option):
Gas faults may be caused by too low or
420/100
500/60
0.5-30.0
EURO
0.6-2.4
0.6 (6.0)
100
100
192x229x270
EN/IEC60974-5.
EN/IEC60974-10
7
IP21
manuals search engine
Software
In case of exchange of the control PCB, software must
be reloaded, using an SD card.
Latest software can be downloaded under Product
software at www.migatronic.com. Save the software
on an SD card containing the folders and one or more
is
2
of the files shown below.
To order SD card, use item no. 78861297.
MIGA_SW
Software loading
• Insert the SD card into one of the control boxes in
either power source or remote control unit.
• Turn on the machine.
• Wait until the LED at the front of the RWF
starts flashing.
• Turn off the machine and remove the SD card.
• The RWF unit is now ready for use.
2
• RWF -enheden er nu klar til brug.
2
Maintenance
Clean the RWF unit with compressed air and check the
2
wire feed rolls for wear and tear, as needed.
SIGMA
10020115.cry
(control software package)
unit
2
9