Cembre B500 Bedienungsanleitung Seite 6

WARNING
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be
careful to maintain a balanced working position.
Before starting work on electrical equipment, please ensure that either
there are no live parts in the immediate working area or that precautions
are taken for working near live parts in accordance with EN50110-1.
Do not use this tool on or near energised conductors without proper
personal protective equipment. Failure to observe this warning could
result in severe injury or death.
The tool is unsuitable for continuous use and should be allowed to cool
down following uninterrupted, successive crimping operations; for instance,
having exhausted a fully charged battery in one session, delay battery
replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and
battery. Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
mum pressure, without dies inserted in the head.
The part reference includes the following (Ref. to Fig. 8 page 45):
Hydraulic crimping tool.
A -
Li-Ion rechargeable battery (2 pcs).
B -
Battery charger (model depends on the tool version).
C -
Shoulder strap.
D -
Plastic carrying case.
E -
2.1) Preparation
The tool can be easily carried using either the handle or the shoulder strap attached to
ring (10) (Ref. to Fig. 6).
Downloaded from www.Manualslib.com
IMPORTANT: In order to avoid damaging the tool, do not operate it at maxi-
Before starting any work, check the battery charge (Ref. to § 2.8) and recharge
if necessary, following the instructions in the battery charger user
manual.
manuals search engine
6