Cembre B500 Bedienungsanleitung Seite 10

4. DISPLAY
The OLED display switches on automatically when the operating or pressure release but-
tons are pressed, and o after 60 seconds of non-operation.
The display shows:
- The main operational parameters of the tool processed by the circuit board, such as
peak pressure or force reached.
- Information on the condition of the tool, such as the charge level, the battery tem-
perature and maintenance requirements.
- Any operational or procedural ERRORS.
Use the touch button (8) to navigate through the menu screens to manage INFORMA-
TION AND SELECTION:
4.1)
INFORMATION SCREENS: display a pre determined parameter which will then
appear each time the tool is started and during the entire work cycle.
F = 60.0 kN
m
Fp = 24.5 kN
P = 661 bar
m
Pp = 312 bar
F = 6.75 ton
m
Fp = 2.75 ton
P = 9587 psi
m
Pp = 4525 psi
BATTERY
B500
NR 13AJ002
Downloaded from www.Manualslib.com
Fm: Minimum set force, expressed in kN.
Fp: Peak force reached, expressed in kN,
(screen as factory setting)
Pm: Minimum set pressure, expressed in bar.
Pp: Peak pressure reached, expressed in bar.
Fm: Minimum set force, expressed in US tons.
Fp: Peak force reached, expressed in US tons.
Pm: Minimum set pressure, expressed in psi.
Pp: Peak pressure reached, expressed in in psi.
Battery charge level.
1000
No. of cycles performed.
No. of cycles before scheduled recommended maintenance.
-19000
Cembre logo, tool model.
tool serial no.
manuals search engine
10