Cembre B500 Bedienungsanleitung Seite 12

4.4)
ERRORS: these appear during operation, combined with a beep and ashing
LED Worklights, to notify the operator of procedural or operational errors.
Message
ERROR
Error screens are displayed for about 30 seconds before being reset, but will
display repeatedly in the event of permanent anomalies.
5. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown, contact your local Agent who will advise you on the
problem and give you the necessary instructions on how to dispatch the tool
to our nearest service Centre; if possible, attach a copy of the Cembre Test
Certi cate supplied with the tool or, if no other references are available, indicate
the approximate purchase date and the tool serial number.
Downloaded from www.Manualslib.com
Error description
The pressure release button (5)
was pressed before the control
parameters were reached (Force/
Pressure).
Abnormal power consumption
of the motor for more than 3
001
seconds.
The tool stops.
002
Output Vage of the pressure trans-
mitter is out of the pre-set range.
002
Failure to reach the set pressure
003
within 30 seconds of continuous
003
operation of the machine.
Overcharging of the battery with
004
protection tripping.
The tool stops.
004
manuals search engine
Solution
Repeat the work cycle and wait for the
motor to stop automatically.
Wait for the display to turn o (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Wait for the display to turn o (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
12