Inhaltsverzeichnis
Werbung
HYDROMASSAGE
Turn on the main switch and wait a few seconds until the
start-up process has completed.
To start the hydromassage, press the button located at the
edge of the tank; press it again to turn off the function.
We recommend leaving the hydromassage active for a dura-
tion of 15-20 minutes (5-10 minutes are necessary before the ac-
tion of the moving water begins to take effect).
We recommend setting the water temperature at approxi-
mately 36 °C; in the instance of higher temperatures, it is advis-
able to reduce the duration of the hydromassage:
34-36 °C --> 20 minutes of hydromassage
36-38 °C --> 15 minutes of hydromassage
38-40 °C --> 10 minutes of hydromassage
Downloaded from
www.Manualslib.com
5-6 cm
manuals search engine
1
3
Soap and bath foams (where not used as part of hydromas-
sage) must only be used when the hydromassage is not in use.
Always turn off the hydromassage and main switch before
emptying the tub.
ATTENTION! In the case of a power failure, it is recommended
to turn off the main switch to prevent the hydromassage from
turning on automatically with the tank empty once the power
has returned.
SANITIZATION
We recommend the J-MX 07 liquid, offered by Jacuzzi and available
at the Assistance Centres/Authorised Retailers, is used to clean the
tub hydraulic circuit (approximately once a month dependent on
how often the hydromassage is used).
IT IS possible to carry out this cleaning operation using the
same water used for the hydromassage provided that soap, oils,
cosmetics,have not been used; otherwise, empty the tub and fill it
once again.
In any case, the tub water level (free of concentrates) must be ap-
proximately 5-6 cm above the highest jets.
22
22
on/off
Werbung
Inhaltsverzeichnis
