Storch Airless ST 2000 Bedienungsanleitung Seite 176

7. Set the circulation switch to the bottom DRAIN positi-
on and then turn to QuickFLUSH.
8. Point the gun at the waste pail, hold it against the wall
of the bucket and press the trigger to thoroughly clean the
system until you see clean flushing liquid. Release trigger
and engage the trigger lock.
9. Turn the circulation switch down to DRAIN position
and allow flushing liquid to circulate until it looks clear.
10. Turn the circulation switch to the front SPRAY posi-
tion. Point the gun at the flushing bucket and press the
trigger to pump the material out of the hose.
Original instruction
11. Lift the pump out of the flushing liquid and allow the
spraying device to run for approx. 15 to 30 seconds to
discharge all the liquid from the device. Switch off the
power (set to OFF).
12. Turn the circulation switch to the bottom DRAIN posi-
tion. Unplug the mains plug.
13. After flushing with water, flush again with CoroCheck
to create a protective film in the device thus avoiding
freezing and corrosion damage.
14. Wipe the spraying device, hose and spray gun with a
rag that you moistened with water or solvent-based clea-
ner.
176