Storch Airless ST 2000 Bedienungsanleitung Seite 172

Spray
1. Apply a spray test pattern. Increase pressure to elimi-
nate heavy edges. Use smaller tip size if pressure adjust-
ment can not eliminate heavy edges.
If this still does not work, reduce the material viscosity
(note material manufacturer's specifications).
2. Hold gun perpendicular, 25 - 30 cm from surface.
Spray back and forth. Overlap by 50 %. Trigger gun after
moving and release before stopping.
Nozzle table/nozzle selection guide
Glazes
Processable
Alkyd resin lacquer
materials
Acrylic lacquer
Spray width 7 8 9
10 cm 207 208 209
15 cm 307 308 309
20 cm 409
25 cm
30 cm
35 cm
40 cm
Original instruction
Interior emulsions
Primers
Exterior emulsions
Pre-coats
Adhesive for fibreglass wallpaper
Nozzle drilling in 1/1000" (example: 8 = 0.008") and nozzle marking
10 12 14 15 16 17
210 212 217
310 312 315 317
410 412 415 417
511 512 514 515 516 517
Clearing Tip Clogs
To avoid serious injury, never point gun at your hand or
into a rag.
1. Engage trigger lock. Rotate spray tip to unclog position.
Disengage trigger lock. Trigger gun at waste area to clear
clog.
Flame protection
Bitumen material
Light filler
19 21 23 25 27 31
319
419 421 423 425 431
519 521 523 525 527 531
619 621 623 625 631
721
821 827
172
Other spray fillers
35 37 39 41 43
535 543
635 637 639 641 643