NEC MultiSync LCD1810 Serie Benutzerhandbuch Seite 14

Controls
ALL RESET
MultiSync
Selecting ALL RESET when D-SUB input is selected allows you to reset all
OSM control settings for the D-SUB input back to the factory settings.
Selecting ALL RESET when BNC input is selected allows you to reset all
OSM control settings for the BNC input back to the factory settings.
Individual settings can be reset by highlighting the control to be used and
pressing the RESET button.
MultiSync LCD
Selecting ALL RESET allows you to reset all OSM control settings back to the
factory settings. Individual settings can be reset by highlighting the control to
be used and pressing the RESET button.
Information
Indicates the current display resolution, frequency setting and type of
Sync signal the monitor is using.
NOTE: Mode Change should only be used if a resolution is not
recognized by the monitor. The user can change to the
appropriate resolution by selecting the Mode information
and selecting (increase or decrease) the corresponding
option.
NOTE: If the
then Sync Type is switched between Separate Sync and Sync
On Green.
78133813.wpc
cont.ols
LCD monitor only
® ™
1810
monitor only
™
2010
or button is pressed while TYPE is highlighted,
12
14 10/28/99, 3:22 PM