Before Testing; Control Solution Testing - Fora COMFORT plus G30a Bedienungsanleitung

If you do not want to set an alarm, press SET to skip this step.
If you want to turn off an alarm, find the alarm number by
pressing SET in the setting mode, press M to change from
"ON' to "OFF".
At the time of your alarm, the meter will beep and
automatically turn on. You can press M to silence the alarm
and insert a test strip to begin testing. If you do not press M,
the meter will beep for 2 minutes then switch off. If you do
not want to test at this time, press M to switch off the meter.
Press SET to turn off the meter. The meter repeats all your
BATTERY
SET
BATTERY
SET
settings before shutdown.
Congratulations! You have completed all settings!
Note:
• These parameters can ONLY be changed in the setting
mode.
• If the meter is idle for 3 minutes during the setting mode, it
will switch off automatically.

Before Testing

Control Solution Testing

Our Control Solution contains a known amount of glucose
that reacts with test strips and is used to ensure your device
and test strips are working together correctly.
Test strips, control solutions, or sterile lancets may not
be included in the kit (please check the contents on your
product box). They can be purchased separately. Please make
sure you have those items needed for a blood glucose test
beforehand.
Do a control solution test when:
you first receive the device.
9 9
you begin using a new vial of test strips.
9 9
you suspect the device or test strips are not working
9 9
properly.
your blood glucose test results are not consistent with
9 9
EN-6