Leckey Mygo Benutzerhandbuch Seite 61

7.3 How to attach the tray
receiver and tray
First of all ensure that your tray is configured
to the size of your stander.
For the Size 1 the brackets on the tray bars
should point outwards (a).
For the Size 2 the brackets on the tray bars
should point inwards (b).
If you need to change the configuration;
remove the Allen bolts (c), swap the bars
over (d) then replace the Allen bolts and
retighten (e).
A
C
D
Before inserting the tray receivers the clamp
plate for the height adjustment of the tray
must be moved out of the way, as it is
contained in the top of the hip pad extrusion.
To do this; loosen the knob at the top of
the hip pad (f) and push it in, this will push
the clamp plate out of the way of the tray
receiver bar. Then insert the tray receiver
bar into the top of the hip pad extrusion (g),
move it down to the required height and
retighten the knob securely.
Repeat on the opposite side. Now you can
insert your tray by inserting the tray bars into
the receivers to the required depth from the
front for prone and the back for supine then
retighten securely using knob on receiver (h).
G
E
B