Qlima D 410 Gebrauchsanweisung Seite 104

+/- Button

Under free drying mode press these buttons to adjust set humidity. Invalid under
other modes.
• Pressing + button will increase humidity while pressing - button will decrease
humidity. The display range of humidity is 35%~80%. Each pressing will increase/
decrease humidity by 5%.
• Continuous Dehumidify Setting: This function can be set by pressing CONTINUOUS
button.
[Attention] : When selecting CO mode, drain hose has to be i Otherwise, unit will
• When unit is in operation, holding + and - button simultaneously for 3s can lock
buttons. If this function is turned on, Button Locked Indicator will be on and
display window shows LC, which will blink for 3 times. Then ambient humidity is
displayed again. To turn off this function, hold + and - button simultaneously for
3s and the indicator will be off.
Display

Shows the set % humidity level while setting, then shows the actual (± 5% accuracy)
room % humidity level.
FILTER Button
4
Press this button to turn off Filter Cleaning Indicator. (When dehumifier has been
operating for 250 hours, Filter Cleaning Indicator will be lite up to remind user of
filter cleaning.)
OTHER INSTRUCTIONS
1 Alarm Warning
If bucket is full or not locked into place for over 3min, buzzer will go off for 10s to
remind you to empty bucket or put it back into the correct place.
2 Auto Stop
When bucket is full, removed or not placed correctly or the humidity is 5%lower than
the set humidity, unit will automatically stop.
3 Memory Function
If power is lost, all of the control settings are remembered. So when power is restored,
the unit will start back up in the settings it was in when power was lost.
4 Bucket full light
This indicates that bucket is full or removed or not placed correctly.
5 Clean the Filter On indicator light
When dehumifier has been operating for 250 hours, Filter Cleaning Indicator will be
lite up to remind user of filter cleaning.
4
104 104
stop when water bucket is full.