Error Messages - Klarstein Iceblock Bedienungsanleitung

Store appliance after end of season
If you do not intend to use or store the appliance for a long period of time, please follow
these steps:
• Remove the plug from the water drain of the appliance and empty the water tank.
• Let the appliance run in fan mode for 2 hours until the inside of the appliance is dry.
• Switch off the appliance and unplug the power plug from the power outlet.
• Clean the filters and put them back in the appliance. Remove the exhaust hose and
store it properly. Remove the battery from the remote control.
• Cover the appliance with a plastic bag and place it in a dry place.
Reconnect the appliance at the start of the season
If you have not used the appliance for a longer period of time, please observe the
following instructions when putting it back into operation:
• Check that the water drain plug and filters are correctly installed.
• Inspect the power cord for damage. If it is damaged, do not use the appliance and
have it replaced by a specialist company.
• Reinsert the batteries in the remote control.
• Install all accessories according to the instructions in the „Installation" section.

ERROR MESSAGES

E1 Coil temperature sensor error
E2 Error of the indoor temperature sensor
E4 Frost protection function: If the coil temperature is too low, the
appliance is switched off. If the temperature rises above 8 °C, the
protection is released and the previous operating state is restored.
EN
41