Cleaning And Maintenance - Klarstein Iceblock Bedienungsanleitung

Timer
• In standby mode, press the TIMER button to program the timer start time. Press the
Plus and Minus (Up and Down) buttons to set a delay time (0-24 hours). The TIMER
indicator lights up. Once the entered time has elapsed, the appliance will start
automatically.
• During operation, press the TIMER button to program the timer end time. Press the
Plus and Minus (Up and Down) buttons to set the timer running time (0-24 hours).
The TIMER indicator lights up. Once the entered time has elapsed, the appliance
switches off automatically.

CLEANING AND MAINTENANCE

CAUTION
Risk of electric shock! Turn the appliance off and unplug the power
cord before cleaning, servicing or repairing the appliance.
This product is equipped with an automatic water vaporization system. The condenser is
cooled by the circulation of the condensed water to improve the cooling capacity and
save energy.
Draining the water tank
When the water tank is full, the screen displays „FL" and the compressor stops
automatically. In this case, empty the tank immediately so that the appliance can
continue. Follow the steps below:
1. Pull the mains plug before removing the exhaust air hose.
2. Move the appliance to a drain or a collection container.
3. Remove the plug from the water drain of the appliance and allow all water to drain
out.
4. Replace the water drain plug.
5. Reinstall the exhaust air hose and start the appliance.
Clean appliance surface
• Unplug the power cord before cleaning.
• Wipe the appliance with a soft, slightly damp cloth. Do not use chemical cleaners,
such as benzene, alcohol or gasoline, as they may damage the surface of the
appliance or even the entire appliance.
• Do not use water, it could penetrate the appliance and damage the electronics.
EN
39