Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE AND CARE
Clean the treadmill
•
Disconnect all power before servicing the treadmill
•
Add a little mild detergent to the 100% cotton cloth. Do not spray the detergent directly on the wal-
king belt ore use acidic and corrosive detergent.
•
Do not wipe under the walking belt.
•
After a period of exercise, dust and stains may appear on the rear floor. This is normal - just wipe.
Walking Belt Slipping and Correction
•
Start the treadmill and run at a speed of 3 km/h.
•
Walking belt to the left: Turn the left adjusting hole screw clockwise by 1/4 turn.
•
Walking belt to the right: Turn the right adjusting hole screw clockwise by 1/4 turn.
•
Walking belt slipping: Turn the left and right adjusting screws clockwise for 1/2 turn at the same
time.
•
After each adjustment, it need to run for a period of time (1-2 minutes) to observe the correction.
Please adjust again if necessary.
Walking belt lubrication
•
Power off the treadmill and unplug the power cord.
•
Lift the edge of the walking belt and smear the inner surface with silicone oil.
•
Start the treadmill to run at a speed of 3 km/h for 10-20 seconds.
•
5-10 ml of silicone oil is required for one lubrication. Excessive application may cause slipping and
affect normal use.
•
Lubricate your walking belt every three months.
42
Werbung
Inhaltsverzeichnis
