Specifications - Jet JSG-233A-M Gebrauchsanleitung

4.0 Specifications
Table 1
Model number
Motor and Electricals
Motor type
Motor power
Voltage
Listed FLA (full load amps)
Motor speed
Starting amps
Starting capacitor
On/off switch
Power cable
1
Recommended circuit size
Sound emission (acoustic pressure level LpA, EN ISO 11202)
Sanding disc
Disc diameter
Disc speed
Sanding belt
Sanding belt size
Sanding belt speed
Belt arm inclination
Sanding table
Table size
Table tilting range
Dust collection
Dust port outside diameter
Recommended minimum extraction volume
Main materials
Machine base
Sanding arm
Sanding disc
Sanding table
Dimensions
Assembled dimensions, LxWxH
Shipping dimensions, LxWxH
Weights
Net weight (approx.)
Shipping weight (approx.)
1
Subject to local/national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace conditions
vary, this information is intended to allow the user to make a better estimation of the hazards and risks involved only.
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.
1~230V, PE, 50Hz
H05RN‐F, 3x1.0 mm
2
71 dB idling, 84 dB in operation
aluminium die casting
aluminium die casting
350 x 400 x 500 mm
6
JSG‐233A‐M
induction motor
0.37 kW (0,5 HP)
3.8 A
2850 /min
12 A
100uF, 125VAC
magnetic switch
2
10 A
200 mm
1850 /min
100 x 915 mm
8 m/sec
0°‐90°
225 x 115 mm
90° ‐ 45°
38 mm
3
80 m /h
Cast iron
steel
26 kg