Starting Operation - ProMinent DULCO Trans 40/1000 PVDF Betriebsanleitung

Safety instructions, Starting Operation
 Before starting operation, check if lever is reset
 The outside condition of the hand nozzle has to be controlled
 Regularly check the hose clamp for tight fit.
 Check outlet tube and seal for tight fit. If necessary,
 When using a hand nozzle with an attached key button,
 Only use the hand nozzle with safety handle.
 Non-compliance with the safety instructions may cause

Starting operation

 Ensure that the supply voltage corresponds with
 Always check power supply cable for damage before starting
 Keep solvents away from the power supply cable.
 Only switch the motor on when the pump is in the liquid.
 Before inserting the plug to the socket, ensure that
 Insert the plug.
 Switch on the motor.
Downloaded from www.Manualslib.com
automatically to starting position.
by regular visible checks. Regularly check swivel joint (hose
connector with o-ring), nozzle housing, outlet tube and safety
handle. These parts are particularly subject to wear and dirt
accumulation.
tighten again outlet tube and/or replace seal.
only use the key button with a safety extra-low voltage.
Generally replace a defect signalling cable.
injuries to the operator, pollution of the environment or
damage to the hand nozzle.
the voltage indicated on the name plate.
 Never operate the pump unless the union nut between
motor and pump has been firmly tightened.
 Immerse the pump vertically into the liquid and secure it in a
vertical position by the use of a barrel fitting or a screw clamp.
operation.
on/off-switch is set to "0" (Stop).
manuals search engine
16