CHIEF iC Serie Installationsanleitung Seite 16

iCMPSA4
3C
100 x 100mm Recessed Mounting Hole Pattern
IMPORTANT!
into back surface of display.
WARNING:
DAMAGE TO EQUIPMENT! It is the installer's responsibility to make sure the combined weight of all components
attached to the iCMPSA4 does not exceed 75 lbs (34 kg).
1. Ensure Centris bracket can swivel and tilt easily, yet still be tight enough to hold display in desired position. Adjust as
required before proceeding. See "ADJUSTMENT."
2. Carefully place display face down on protective surface.
CAUTION:
completely thread into display mounting holes.
3. Place four spacers (CC) over mounting holes in display back.
4. Orient mount so that teardrop mounting holes in Centris bracket are aligned with holes in four spacers (CC).
WARNING:
SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
5. Using a Phillips screwdriver, install four screws (P) through four teardrop mounting holes in Centris bracket and
spacers (CC) into display. Tighten all four screws (P). Do not overtighten!
6. Continue with "INSTALL SWING ARM TO BASE PLATE".
16
Downloaded from www.Manualslib.com
This procedure only applicable when 100x100mm mounting holes on back of display are recessed
EXCEEDING THE WEIGHT CAPACITY CAN RESULT IN SERIOUS PERSONAL INJURY OR
USING SCREWS OF IMPROPER SIZE CAN DAMAGE DISPLAY! Screws should easily and
INADEQUATE THREAD ENGAGEMENT IN DISPLAY CAN LEAD TO MOUNT FALLING CAUSING
5 P x 4
CC x 4
3
4
TOP
manuals search engine
Installation Instructions
1