CHIEF iC Serie Installationsanleitung Seite 11

Installation Instructions
1
2
1/4" (6.3mm)
1A
1
2
3/8" (10mm)
(H) x 2
4
9/16" (14.2mm)
Downloaded from www.Manualslib.com
1 x 2
x 2
(H) x 2
3
(G) x 2
9/16" (14.2mm)
x 2
x 2
3
(F) x 2
(B)
(G) x 2
manuals search engine
INSTALL BASE PLATE TO WALL
Wood Stud Installation
WARNING:
STRUCTURAL STRENGTH FOR THIS COMPONENT
CAN RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the combined
weight of all equipment. Reinforce the structure as required
before installing the component.
1. Level base plate (B) and mark locations of pilot holes.
2. Drill two 1/4" (6.3mm) diameter pilot holes into wood studs
at marks.
3. Using 9/16" (14.2mm) socket wrench, install two lag
screws (G) through two flat washers (H) and base plate
(B) into wood studs.
(B)
Concrete Installation
WARNING:
STRUCTURAL STRENGTH FOR THIS COMPONENT
CAN RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the combined
weight of all equipment. Reinforce the structure as required
before installing the component.
1. Level base plate (B) and mark locations of pilot holes.
2. Drill two 3/8" (10mm) diameter pilot holes into mounting
surface.
3. Install two anchors (F) into pilot holes.
4. Using 9/16" (14.2mm) socket wrench, install two screws
(G) through two flat washers (H) and wall plate (B) into two
anchors (F).
CAUTION:
FAILURE TO PROVIDE ADEQUATE
FAILURE TO PROVIDE ADEQUATE
Do NOT overtighten screws!
iCMPSA4
11