CHIEF iC Serie Installationsanleitung Seite 13

Installation Instructions
3
INSTALL DISPLAY
IMPORTANT!
3A
Downloaded from www.Manualslib.com
Proceed as directed below:
• If installing a display with a 200x100, 200x200, 300x300, 400x200, or 400x400mm mounting hole pattern,
proceed to Step 3A.
• If installing a display with a 100x100mm mounting hole pattern, proceed to step 3B or 3C, as applicable.
E x 2
1
4
manuals search engine
200x100, 200x200, 300x300, 400x200 or
400x400 Mounting Hole Pattern
Attaching Vertical Brackets
WARNING:
LEAD TO MOUNT FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! DO NOT substitute hardware. Only
use hardware provided or specified by manufacturer.
1. Determine and mark the vertical center position
between the left side upper and lower mounting
Mounting
holes in display.
Holes
2. Determine and mark the vertical center position
between the right side upper and lower mounting
holes in display.
3. Orient vertical mounting bracket (E) so that
mounting holes are on top and mounting slots are
on bottom.
4. Align mounting holes and slots in vertical mounting
Mounting
bracket (E) with upper and lower mounting holes in
Slots
display.
5. Adjust vertical mounting bracket (E) position until
mark made in Step 1 aligns with center mark in
vertical mounting bracket (E).
6. Secure left side vertical mounting bracket (E) to
display using two Phillips pan head screws (N
through AA).
NOTE:
NOTE:
7. Repeat Steps 3 through 6 for right side vertical
mounting bracket using the same hole locations to
align brackets horizontally.
IMPROPER INSTALLATION CAN
Also use #10 flat washers (BB) if using screws
N or P.
If the display has a recessed mounting surface,
protrusions or a power box, a spacer and
longer mounting hardware must be placed
between the display and vertical mounting
brackets (E).
iCMPSA4
13