CHIEF iC Serie Installationsanleitung Seite 12

iCMPSA4
2
12
Downloaded from www.Manualslib.com
1
(A)
(B)
2
manuals search engine
INSTALL SWING ARM TO
BASE PLATE
IMPORTANT!
If the display has a 100 x 100mm
recessed mounting hole pattern, then display must be
mounted to swing arm (A) before swing arm is
installed to base plate (B). See "INSTALL DISPLAY,
100 x 100mm Recessed Mounting Hole Pattern".
Continue below after display is installed.
CAUTION:
PERSONAL INJURY MAY OCCUR IF
SWING ARM COLLAPSES AGAINST FINGERS!
Be alert, keeping hands and fingers out of pinch
points during installation.
1. Slide swing arm mounting bracket (A) down into
base plate (B).
2. Secure swing arm (A) to base plate (B) by
tightening screw with hex key (K).
(K)
Installation Instructions