Side Brushes; Battery Replacement And Charging - cecotec CONGA 5090 Bedienungsanleitung

7. If the Scrubbing mode has been used, empty the water tank and then fill it with clean
water to rinse it. Empty it again before installing it back in the robot.
High-efficiency filter
Remove the high-efficiency filter and shake it to remove all the dust.
Note:
• Replace the high-efficiency filter every 3 months depending on
the frequency and type of use.
• Clean the filter periodically with a brush to avoid blockage. Do
not use water or detergents.

SIDE BRUSHES

Remove and clean the side brushes regularly.
Note: In order to ensure a perfect cleaning, it is suggested to replace
the side brushes every 3 months, depending on the frequency and
type of use.
FREE-FALL SENSORS
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in
its original package.

8. BATTERY REPLACEMENT AND CHARGING

• Do not use any other battery, power adapter or charging base than the one provided officially
by Cecotec.
• Do not use non-rechargeable batteries.
• Do not remove, dismantle or attempt to repair the battery or the charging base.
• Do not place the charging base near heat sources.
• Do not use a wet cloth to wipe any of the parts of this product.
• If the robot is not going to be used for a long time, remove the battery from the product and
4 5
ENGLISH
6
43