Operation - Klarstein Tomahawk Bedienungsanleitung

OPERATION

Energy saving tips
• Reduce the opening time of the lid.
• Turn the grill off as soon as cooking is completed.
• Preheat the gas grill for 10 to 15 minutes only. (Except for the first use)
• Do not preheat longer then recommended.
• Do not use a higher setting than required.
• Connect the hose and regulator to the gas cylinder at the left side of the gas
grill keeping in mind that the gas cylinder must be kept away from heat and in
a safe position .The hose dimension is 8-10 mm diameter. The length of hose
recommended which shall not exceed 1.5 m.
Note: The lid must be open when lighting the burner! Do not stand with your face
directly over the gas grill when lighting it.
Lighting the grill
The burner has the following ignition procedure:
Ignition with control gas control (main burner or main burner with side burner or main
burner with side burner and side burner).
• When all the switches on the gas grill are in the „Off" position, turn the gas cylinder
valve to the „On" position.
• To generate a spark, press and hold the throttle control knob (A) for 3-5 seconds to
allow the gas to flow, then turn counterclockwise to „HIGH" (B).
• The spark can then pass to the burner tube (C). You will hear a „snap" noise from
the igniter and you will see an orange flame coming out of the burner tube on the
left side of the burner (D).
• After the „snap" sound, keep the gas regulator pressed for two seconds so that the
gas can flow completely through the burner tube (E) and ignition is guaranteed.
EN
31