Startup; Starting Up The System; Operating Notes - Balluff BMF 415KW-HA W-5-Serie Betriebsanleitung

BMF 415KW-HA _ _ _ -W-5- _ _ -...
Magnetic Field Sensors
5

Startup

5.1

Starting up the system

DANGER
Uncontrolled system movement
When starting up, if the sensor is part of a closed loop
system whose parameters have not yet been set, the
system may perform uncontrolled movements. This
could result in personal injury and equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and readjust the BMF if necessary.
Check for the correct values, especially after
replacing the BMF or after repair by the
manufacturer.
5.2

Operating notes

CAUTION
Elevated housing temperature
If the installation does not provide sufficient thermal
coupling, the surface temperature of the BMF may rise to
over 50 °C and cause burns when touched.
► Improve the thermal coupling of the installation.
► Reduce the load.
► Do not touch the surface.
– Regularly check function of the BMF and all associated
components.
– Take the BMF out of service whenever there is a
malfunction.
– Secure the system against unauthorized use.
– Check fasteners and re-tighten if needed.
– The sensor features overload protection. After the
overload is eliminated, the sensor is once again
functional.
www.balluff.com english 11