Ambient Conditions; Electrical Characteristics - Balluff BMF 415KW-HA W-5-Serie Betriebsanleitung

BMF 415KW-HA _ _ _ -W-5- _ _ -...
Magnetic Field Sensors
7
Technical data
7.1 Detection range/measuring range
Assured switching field
strength H
1)
a
7.2

Ambient conditions

Ambient temperature
Contamination scale
Degree of protection
7.3 Displays
Operating voltage indicator
Function indicator
Fault indicator
7.4

Electrical characteristics

Rated operating voltage U
Rated operating current I
e
Rated insulation voltage U
Operating voltage U
b
BMF...-HAPS/HANS-...
BMF...-HAKKI-...
Utilization category
Turn-on delay t
on
Interference suppression
time t
DSD
Turn-off delay t
off
Load capacity max.
No-load current I , undamped 18 mA
omax
Magnetic field frequency, AC
interference field
Interference magnetic field
strength, AC & DC
Residual current I max.
r
Voltage drop U static
d
20 english
5.2 kA/m (6.5 mT)
0...80 °C
3
IP67
Green LED
Yellow LED
Red LED
24 V DC
e
50 mA
75 V DC
i
10...30 V DC
18...30 V DC
DC-13
Same as the
interference
suppression time t
DSD
starting from the point
where no more
interference is detected
600 ms preset
(can be set from
50...1000 ms on
IO-Link versions)
Same as the
interference
suppression time t
DSD
starting from the point
where no more
interference is detected
1.5 µF
45...65 Hz
110 kA/m
≤ 10 μA
≤ 1.5 V
7.5 Electrical connection
Connection type
Cable, 2 m
Cable with connected plug,
0.3 m
Cable diameter D
3-conductor PUR connection
cable
3-conductor silicon
connection cable and
IO-Link connection cable
Polarity reversal protected
Protected against miswiring
Short-circuit resistance
7.6 Output / interface
Switching output
BMF...-HAPS-...
BMF...-HANS-...
IO-Link versions
7.7 Mechanical data
Dimensions
BMF 415...
with weld splatter shield
Tightening torque
Materials
Housing material
Weld splatter shield
Installation
7.8 Functional security
MTTF (40 °C)
Required magnetic minimum field strength over the entire temperature
1)
range, measured axially in the slot base
Lead contacting
M8 and M12
2.4 mm
3.2 mm
yes
yes
yes
PNP normally open
NPN normally open
configurable
34 × 5 × 6.2 mm
40 × 6.2 × 7.9 mm
0.7 Nm
PA12
PESU, transparent
for insertion in T-slot
from above
420a