Example Of Connection; Sensor Supply Connection; Interface Connection - Baumer BE134 Betriebsanleitung

BE134
Sensor
Contact
Proximity switch PNP or NPN
Namur without explosion protection
26

3.5 Example of connection

3.6 Sensor supply connection

Connect the sensor supply at terminals 12 and 13 – for example en-
coder supply, etc.
Do not use the sensor supply to supply non-earthed inductive or
capacitive loads. The sensor supply is short-circuit proof (exception
model 24/48 VAC).
Voltage supply
24 VAC
48 VAC
85...265 VAC
12...30 VDC
3.7 Interface connection (Option)
The serial interface can perform the following functions:
- retrieve data
- program parameters
Interface parameters are:
- transmission speed (baud rate),
- parity bit,
- number of stop bits,
- address of controller for master.
The interface parameters can be set on the programming level (Lines
51, 52, 53 and 54).
www.baumer.com
Contact assignment Programming
7/8 Start/Stop
12 +24 V
7/8 Start/Stop
12 +24 V
13 0 V
7/8 Start/Stop
13 0 V
Sensor supply
10...26 VDC
10...26 VDC
24 VDC ±20 %
9...28 VDC ±20 %
Function of signal
inputs:
line 30 to 0, 1 or 2
Input logic:
Line 33 to 0 = PNP
Line 33 to 1 = NPN
Input logic:
Line 33 to 1 = NPN
Current load
60 mA
60 mA
100 mA
100 mA